How to attach a PVC to black PVC pipe?

Over recent years, people have realized that PVC pipes can perform a better job than any other type of traditional pipes. The global PVC pipes market is expected to gain popularity in upcoming years too. There are different types of PVC pipes used for various application. Among them, Acrylonitrile butadiene styrene (ABS) plastic pipe which is often referred to as black PVC is flexible, and are used in applications where flexibility is a must. To form a water-tight seal it is connected to PVC. In this article let’s understand simple tips to attach a PVC to the. black PVC pipe

Steps to Attach White PVC to Black PVC:

Step 1: Loosen Clamps:

You will need to make sure that the stainless steel clamps that are on your rubber coupling are loosened. You do not need to remove them, but just loosen them enough where you will be able to work on them. The best way for you to loosen them is to use your hex-head adapter.

Step 2: Clean the Tubing:

Before you start working make sure that the black ABS and the PVC are cleaned. If there is any dirt or dust on both the ends, then the actual connection process can be interfered with. So, cleaning the tubing is a must and it is simple to clean the tubing. You will simply need to wipe it down using a damp cloth but ensure that the cloth is not wet but slightly damp.

Step 3: Rubber Coupling:

You will have to get one end of your rubber coupling and then slide it over the other end of your black PVC pipe. Once this is done, you will have to get the other end of your coupling and slide it over your white PVC pipe.

Step 4: Tighten:

You are now ready to get the stainless steel clamps tightened. To properly tighten them, you will need to get your tee-handled torque wrench out. You must make sure the clamp sits in the moulded groove portion of the rubber coupling before you start to tighten. You will have to do this step because it will be able to make sure that there is a tight fit without risking damage to either the PVC or Black PVC pipes.

Step 5: Testing the Connection:

Finally, you need to test the connection of the pipe that you are working on because this connection will most likely be used for a type of plumbing or a water application. Because of this, you must take the time to test the connection for leaks before you attempt to install anything or begin work on it. If you begin to run water through your pipe and see any leaks, then you will need to check to make sure that you used the right torque for your clamps. You will need to fix this issue as soon as possible and do not stop until the leaks have ceased. Thus, follow these simple steps to easily attach a PVC to the black PVC pipe.

Edith Lindsay

Leave a Reply

Your email address will not be published. Required fields are marked *